<http://www.pcdvd.com.tw/showpost.php?p=1081019767&postcount=1>
1 Remove power from the Router.
2 Disconnect all your computers and the cable/DSL modem from the Router.
3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL port on the rear of the Router to any one of the LAN ports.
4 Re-apply power to the Router. The Alert LED will flash as the Router starts up, and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to flash slowly, remove power from the Router.
5 Remove the cable connecting the Cable/DSL port to the LAN port, and reconnect one of your computers to one of the Router LAN ports.
6 Re-apply power to the Router, and when the start-up sequence has completed, browse to: http://192.168.1.1
and run the configuration wizard. You may need to restart your computer before you attempt this.
7 When the configuration wizard has completed, you may reconnect your network as it was before.
